ESAB Aristo U8 - 16.3 Creating User-Defined Wire;Gas Options

-- 6 5 --
bi09d1e2
S Select one of the options from the list and press
ENTER.
Fe
Ss (Stainless)
Ss duplex
Al Mg
Al Si
Metal cored Fe
Rutile FCW Fe ↓
S Make a selection for shielding gas in the same way,
and press ENTER.
CO2
Ar+20%CO2
Ar+2%O2
Ar
He
Ar+30%He+1%O2
Ar+2%CO2 ↓
S Make a selection for wire diameter in the same way,
and press ENTER.
0.6 mm
0,8 mm
1.0 mm
1.2 mm
1.4 mm
1.6 mm
2.0 mm ↓
S Select the line for STORE NEW LINE ..... and press ENTER.
The operation is now complete – a synergic line has been defined.
Note! A corresponding dip/spray synergy is needed for each pulsing instance.
When you create a new synergic line for the pulse welding method, you will ther efor e
always receive a warning message if a corresponding line has not been created for
the dip/spray welding method.
WARNING!
No corresponding synergic line
for dip/spray welding
16.3 Creating user--defined wire/gas options
The lists of wire/gas options can be extended to include
up to ten user--defined options. At the bottom of each list
is an empty line (------). If you place the cursor on this line
and press ENTER, you gain access to a ” keyboard” that
allows you to type in your own options.
Ar+15%CO2+5%O2 ↑
Ar+50%He
SELF SHIELDED
Ar+16%CO2
Ar+25%CO2
Ar+1%O2
-- -- --
GB