EW50 Industrial LTE Cellular Gateway
198
PPTP Server Configuration Window
Check the Enable box to enable PPTP server role of the gateway.
1. Required setting
2. Default is
192.168.0.1
Specify the PPTP server Virtual IP address. The virtual IP address will serve as
the virtual DHCP server for the PPTP clients. Clients will be assigned a virtual IP
address from it after the PPTP tunnel has been established.
1. Required setting
2. Default is 10
This is the PPTP server’s Virtual IP DHCP server. User can specify the first IP
address for the subnet from which the PPTP client’s IP address will be assigned.
Value Range: 1 ~ 254.
1. Required setting
2. Default is 17
This is the PPTP server’s Virtual IP DHCP server. User can specify the last IP
address for the subnet from which the PPTP client’s IP address will be assigned.
Value Range: >= Starting Address, and < (Starting Address + 8) or 254.
1. Required setting
2. Unchecked by
default
Select single or multiple Authentication Protocols for the PPTP server with
which to authenticate PPTP clients. Available authentication protocols are PAP /
CHAP / MS-CHAP / MS-CHAP v2.
1. Required setting
2. Unchecked by
default
Specify whether to support MPPE Protocol. Click the Enable box to enable
MPPE and from dropdown box to select 40 bits / 56 bits / 128 bits.
Note: when MPPE Encryption is enabled, the Authentication Protocol PAP /
CHAP options will not be available.
Click Save button to save the settings.
Click Undo button to cancel the settings.
PPTP Server Status Window
Displays the User Name, Remote IP, Remote Virtual IP, and Remote Call ID of
the connected PPTP clients.
Click the Refresh button to renew the PPTP client information.