EW50 Industrial LTE Cellular Gateway
223
Edit/Backup Plain Text Command Script
You can edit the plain text configuration settings in the configuration screen as shown above.
Clean text area. (You should click Save button to further clean the configuration
already saved in the system.)
Backup and download configuration.
The supported plain text configuration items are shown in the following list. For the settings that can be
executed with standard Linux commands, you can put them in a script file, and apply to the system
configuration with the STARTUP command. For configurations without a corresponding Linux command set to
configure, you can configure them with a proprietary command set.
Enable or disable OpenVPN Client function.
Specify the tunnel name for the OpenVPN Client connection.
Define the Protocol for the OpenVPN Client.
TCP or TCP /UDP -> OpenVPN will use TCP protocol, and Port will
be set to 443.
UDP -> OpenVPN will use UDP protocol, and Port will be set to
1194.
Specify the Port for the OpenVPN Client to use.
Specify the Remote IP/FQDN of the peer OpenVPN Server for this
OpenVPN Client tunnel. Enter the IP address or FQDN.
Specify the time interval for OpenVPN keep-alive checking.
Specify the timeout value for OpenVPN Client keep-alive checking.
Specify the LZO Compression algorithm for OpenVPN client.
Specify the authorization mode for the OpenVPN tunnel.
TLS -> OpenVPN will use TLS authorization mode, and the
following items CA Cert., Client Cert. and Client Key need to be
specified as well.