EW50 Industrial LTE Cellular Gateway
293
As shown in the screen above, there are some pre-defined SMS event rules. You can customize them with your
own definitions by clicking the Edit button, and enable or disable each rule accordingly.
When the Add or Edit button is applied, the Managing Event Configuration screen will appear.
Managing Event Configuration
SMS (or SNMP Trap) by
default
Specify the Event type (SMS, SNMP Trap, or Digital Input) and an event
identifier / profile.
SMS: Select SMS and enter the message in the textbox as the trigger condition
for the event;
SNMP: Select SNMP Trap and enter the message in the textbox to specify the
SNMP Trap Event;
Digital Input: Select Digital Input and a DI profile you defined to specify a
certain Digital Input Event;
Note: The available Event Types will depend on product model.
Enter a brief description for the Managing Event.
All boxes unchecked by
default.
Specify Network Status, or at least one action to take when the expected event
is triggered.
Network Status: Select Network Status Checkbox to get the network status as
the action for the event;
LAN&VLAN: Select LAN&VLAN Checkbox and the relevant sub-items (Port link
On/Off), and the gateway will change the settings as the action for the event;
Wi-Fi: Select Wi-Fi Checkbox and the relevant sub-items (Wi-Fi radio On/Off),
the gateway will change the settings as the action for the event;
NAT: Select NAT Checkbox and the relevant sub-items (Virtual Server Rule
On/Off, DMZ On/Off), the gateway will change the settings as the action for the
event;
To Next Page
Loading...
General