Ethos v1.5.7 and X18, X20 series User Manual
the set icon with an arrow is tapped, the current value of the channel is used.
Alternatively, a fixed value for that channel can be entered by tapping on the value.
No pulses
No Pulses turns off pulses (for use with flight controllers having return-to-home
GPS on loss of signal).
Receiver
Choosing “Receiver” on X series or later receivers allows failsafe to be set in the
receiver.
Warning: Be sure to test the chosen Failsafe settings carefully.
Range check
A range check should be done at the field when the model is ready to fly.
Range check is activated by selecting 'Range check'.
A voice alert will announce ‘Range check’ every few seconds to confirm that you are in
range check mode. A popup will display the Receiver Number, and the VFR% and RSSI
values to evaluate how reception quality is behaving. When the range check is active,
it reduces transmitter power, which in turn reduces the range for range testing. Under
ideal conditions, with both the radio and receiver at 1m above the ground, you should
only get a critical alarm at about 30m apart.
Please refer to the Telemetry section for a discussion on VFR and RSSI values.
To Next Page
Loading...
Need help?
General