Ethos v1.5.7 and X18, X20 series User Manual
The ‘Half range’ option is available when using a 2-POS Switch or logic switch as a
source. The range becomes [0-100%] instead of [-100%-100%].
Source option for trims
By default trims have a range of +/- 25%. When used as a source, trims can
optionally be changed to full range +/- 100% (long press Enter on the trim).
Ignore trainer input
In logic switches the sources may have this option set to ignore sources coming from
the trainer input. A typical application is where a logic switch is configured to detect
movement of the master trainer’s sticks (e.g. Elevator stick) to allow for instant
intervention if things go wrong. This option is needed to prevent the student stick
inputs from triggering the logic switch.
To Next Page
Loading...
Need help?
General