Evector SportStar RTC - Page 129

MAINTENANCE MANUAL
ERTC022-10-AS
Effectivity: All
24-30
Page 24-35
2019-03-22
Edition 2 | Rev. 1
(3) Removal – relay 12 V / 75 A
(a) Switch the electrical network off and disconnect the battery.
(b) Remove the cover of the upper part of fuselage F4 (Section 53-30).
(c) Unscrew the screws (12, Fig. 24-15) attaching the cable eyes (8) to the relay
contacts (6).
(d) Disconnect the connectors (7).
(e) Unscrew and remove the nuts (10) with the washers (11).
(f) Slide out the screws (9) and remove the relay (6).
(4) Installation – relay 12 V / 75 A
(a) Position the relay (6, Fig. 24-15) on the bracket in the upper part of the fuselage.
(b) Insert the screws (9), put the washers (11), screw on and tighten the nut (10).
(c) Using the screws (9), connect the cable eyes (8).
(d) Connect the connectors (7).
(e) Install the cover of the upper part of the fuselage F4 (Section 53-30).
(f) Connect the battery, switch the electrical network on and check the function of the
relay.