MAINTENANCE MANUAL
Page 32-56
Effectivity: All
Edition 2 | Rev. 1
Legend to Fig. 32-21
1 Lever 13 Washer 5,3 (4 pcs.)
2 Bushing 14 Washer 6,5 Nord-Lock
3 Axis 15 Bracket
4 Handgrip 16 Rubber washer (2 pcs.)
5 Valve of parking brake 17 Screw M4x12 (2 pcs.)
6 Screw M5x14 18 Screw M4x8 (2 pcs.)
7 Screw M5x35 19 Nut M4 (2 pcs.)
8 Screw M4x10 (2 pcs.) 20 Washer 4,3 (2 pcs.)
9 Screw M6x16 21 Screw M5x30 (2 pcs.)
10 Nut M5 (3 pcs.) 22 Washer 5,3 (2 pcs.)
11 Washer 5,3 23 Screw M4x10 (2 pcs.)
12 Nylon washer 4,3 (2 pcs.)
Fig. 32-20 Parking brake valve – removal / installation (page 2 of 2)
F. Switch of parking brake signaling
Maintenance type: Line
Personnel
qualification:
Independent verification personnel qualified in accordance with Part
66 or higher
Recommended tools and material:
Item Designation / Size Quantity Note
Wrench No. 4 1 pc.
Flat screwdriver - 1 pc.
Soldering iron - 1 pc.
Solder - -
Hot air gun - 1 pc.
Shrinkable hose ø 3x1 mm -
Locking paint C2001/8140 -
NOTE
The removal / installation procedure applies to both the Matco
valve and the GoldFren valve.
(1) Removal – switch of parking brake signaling
(a) Switch the electrical network off and disconnect the battery.
(b) Remove the handgrip (4, Fig. 32-21) of the lever (1) attached by the screw (9) with
the locking washer (14).
(c) Remove the left cover of the control pull-rod IN1L (Section 25-10).
(d) Using the soldering iron, disconnect the wires (5, Fig. 32-22) from the switch (1).
(e) Unscrew and remove the nuts (3), washers (4) and the screws (2) with the washers
(4).
To Next Page
Loading...
