MAINTENANCE MANUAL
Effectivity: All
Page 32-57
Edition 2 | Rev. 1
(f) Remove the switch (1).
(2) Installation – switch of parking brake signaling
(a) Position the switch (1, Fig. 32-22) to the bracket (7) and attach it by means of
screws (2), nuts (3) and the washers (4).
(b) Slide the new shrinkable hose on the wires (5), connect them to the switch by
means of the soldering iron and solder.
NOTE
Use the wiring diagram shown in Chapter 91.
(c) Cover the joints by the shrinkable hose and carefully warm it up using the gun.
(d) Adjust the mutual position of the switch and the lever:
1 In the area “opened“, the switch must be mechanically connected and
electrically disconnected.
2 In the transitional area and in the area “closed“ the switch must be
mechanically disconnected and electrically connected.
3 Drop the paint on the screw heads (2).
(e) Install the left cover of the control pull-rod IN1L (Section 25-10).
(f) Install the handgrip (4, Obr. 32-21) attached by the screw (9) and the locking
washer (14).
(g) Connect the battery, switch the electrical network on and check the signaling
function.
To Next Page
Loading...
