XTP CrossPoint Series • HTML Operation 121
HTML Operation
The XTP CrossPoint Series can be remotely controlled via:
• The XTP System Configuration Software (see the XTP System Configuration Software
help file, available at www.extron.com).
• SIS commands (see Programming Guide, beginning on page 76)
• Built-in HTML pages (see below)
This section introduces using the built-in HTML pages to operate the XTP CrossPoint
Series, including:
• Download the Startup Page
• Status Tab
• Configuration Tab
• File Management Tab
• Control Tab
The matrix switcher can be controlled and operated through its LAN port, connected via a
LAN or WAN, using a Web browser such as the Microsoft Internet Explorer. The display in
the browser of the status or operation of the matrix switcher has the appearance of Web
pages. This chapter describes the factory-installed HTML pages, which are always available
and cannot be erased or overwritten.
NOTE: If your Ethernet connection to the matrix switcher is unstable, try turning off
the proxy server in your Web browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings, uncheck the Use a proxy
server... box, and then click OK.
To Next Page
Loading...
