XTP CrossPoint Series • Programming Guide 81
Arrangement of Command and Response Tables
Different board types and endpoint types accept different types of commands. There
is some repetition in the command and response tables, depending on the input and
output for which the commands are appropriate. Additionally, basic whole-matrix-switcher
commands, more advanced whole-matrix-switcher commands, and IP- and remote port
setup commands are presented in separate command and response tables.
The following pages present seven command and response tables, each defining a subset
of SIS commands and their responses, with examples where appropriate. The tables that
are presented are listed below. For increased detail as to where each command family is
presented, see the table below, the table on the next page, and the table on page 83.
• SIS Command and Response Table for Basic Matrix Switcher Commands,
starting on page 87 — SIS commands for basic, everyday functions of the
XTP CrossPointSeries matrix switcher frame.
• SIS Command and Response Table for Input-Board-Specific Commands,
starting on page 88 — SIS commands to control and monitor the inputs to the matrix
switcher via assorted input boards.
• SIS Command and Response Table for Input-Endpoint-Specific Commands,
starting on page 96 — SIS commands to control and monitor XTP transmitter and
XTP switcher endpoints from the matrix switcher.
• SIS Command and Response Table for Output-Board-Specific Commands,
starting on page 103 — SIS commands to control and monitor the outputs from the
matrix switcher via assorted output boards.
• SIS Command and Response Table for Output-Endpoint-Specific Commands,
starting on page 107 — SIS commands to control and monitor XTP receiver endpoints
from the matrix switcher.
• SIS Command and Response Table for Advanced Matrix Switcher
Commands, starting on page 111 — SIS commands for advanced functions of the
XTP CrossPoint Series matrix switcher frame.
• SIS Command and Response Table for IP- and Remote Port-Specific
Commands, starting on page 119 — SIS commands to control and monitor the IP
interface and Remote RS-232/RS-422 port of the XTP CrossPoint matrix switcher.
Matrix Switcher Enclosure Commands
Command
family
Basic Advanced IP and Remote Port
Create ties Page 87
View ties Page 88
Recall global presets Page 88
Black video resolution
within matrix switcher
Page 111
Test patterns Page 111
Names Page 111
Front panel locks Page 111
Create global presets Page 112
Resets Page 112
View settings Page 113
File directory Page 114
Information requests Page 115
IP and remote port setup Page 119
To Next Page
Loading...
