XTP CrossPoint Series • Programming Guide 76
Programming Guide
The XTP CrossPoint Series Matrix Switcher can be remotely controlled via:
• The XTP System Configuration software (see the XTP System Configuration Software
Help file, available at www.extron.com).
• Built-in HTML pages (see HTML Operation, beginning on page 121)
• SIS commands (see below)
This section describes the operation of the XTP CrossPoint Series Matrix Switchers via SIS
commands, including:
• Local Host-Control Ports
• Ethernet (LAN) Port
• Host-to-Matrix-Switcher Instructions
• Matrix-Switcher-Initiated Messages
• Matrix Switcher Error Responses
• Using the Command and Response Tables
• SIS Command and Response Table for Basic Matrix Switcher Commands
• SIS Command and Response Table for Input-Board-Specific Commands
• SIS Command and Response Table for Input-Endpoint-Specific Commands
• SIS Command and Response Table for Output-Board-Specific Commands
• SIS Command and Response Table for Output-Endpoint-Specific Commands
• SIS Command and Response Table for Advanced Matrix Switcher Commands
• SIS Command and Response Table for IP- and Remote Port-Specific
Commands
• Special Characters
To Next Page
