RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-9
Resolving a Card Not Fed Error (Two (2) or more card feed at the
same time)
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
Symptoms: Two or more cards feed at the same time causing the cards to
jam at the Card Hopper Roller. Printer is out of cards.
Printer Error State: Card is not being detected by card TOF Sensor 11
sec after the initiation of a print job causing the Printer to produce an error
LCD Error Display: Card Not Fed
Driver Monitor Error Display: Unable to Feed Card
To Next Page
Loading...
