⚫ Status: check to see if the SIP account is registered or not.
⚫ Account Active: click Enable or Disable to activate or deactivate the
registered SIP account.
⚫ Display Name: configure the name, for example, the device’s name to be
shown on the device being called to.
⚫ User Name: enter the user name obtained from SIP account administrator.
⚫ Account: select the exact account (Account 1&2) to be configured.
⚫ Display Label: configure the device label to be shown on the device screen.
⚫ Register Name: enter the SIP account register Name obtained from the SIP
account administrator.
⚫ Password: enter the password obtained from the SIP account administrator.
9.2.2. SIP Server Configuration
SIP servers can be set up for devices in order to achieve call sessions through
SIP server between intercom devices. To do this configuration also on web
Account > Basic > SIP Server interface.
Parameter Set-up:
⚫ Server IP: enter the primary server IP address number or its URL.
⚫ Server IP: enter the backup SIP server IP address or its URL.
To Next Page
Loading...
