Fasttel FT600KSIP - Configure Exit Button for Door Unlock

FT600(K)SIP Door Phone Administrator Guide
www.fasttel.com FT600(K)SIP
45
Enable field.
⚫ Session Check: this feature is for some network security limitations, if you
enable it, the door may not be unlocked in this way.
⚫ User Name: enter the user name of the device web interface, for example,
“Admin”.
⚫ Password: enter the password for the HTTP command. For example:
“12345”.
Please refer to the following example:
http://192.168.35.127/fcgi/do?action=OpenDoor&UserName=admin&Passwo
rd=12345&DoorNum=1
12.4. Configure Exit Button for Door Unlock
When you need to open the door from inside using the Exit button installed by
the door, you can configure the door phone Input to trigger the relay for the door
access on web Intercom > Input interface.
Parameter Set-up:
Note:
⚫
DoorNum in the HTTP command above refers to the relay number #1
to be triggered for the door access.