20. Integration with Third Party Device
20.1. Integration via Wiegand
If you want to integrate Fasttel door phone with the third party devices via
Wiegand, you can configure the Wiegand on the web Intercom > Wiegand
interface.
Parameter Set-up:
⚫ Wiegand type: set the wiegand data transmission format among three
options: “Wiegand 26”, “Wiegand 34”, “Wiegand 58”. The transmission
format should be identical between the door phone and the device to be
integrated.
⚫ Wiegand Transfer Mode: select Input, Output, Convert to Card
No.OutputWiegand. if the door phone is used as a receiver, then set it as
“Input” for the door phone. Select “Output”
⚫ Wiegand Input Data Order：set the Wiegand input data sequence between
“Normal” and “Reversed” if you select “Reversed” then the input card
number will be reversed and vice versa.
⚫ Wiegand Output Data Order: set the Wiegand output data sequence
between “Normal” and “Reversed” if you select “Reversed” then the input
card number will be reversed and vice versa.
⚫ Wiegand Output CRC: tick to enable the parity check function to ensure that
signal-based data can be transmitted correctly according to the established
data transmission format.
You can configure the wiegand output mode if needed. The output occurs when
you press the PIN code on the device.
To Next Page
Loading...
