Parameter Set-up:
⚫ Video Resolution: select video resolutions among seven options: “QCIF”,
“QVGA”, ”CIF”, ”VGA”, ”4CIF”, ”720P”. The default video resolution is “4CIF”.
and the video from the door phone might not be able to be shown in the
indoor monitor if the resolution is set higher than “4CIF”.
⚫ Video Framerate: “30fps” is the video frame rate by default.
⚫ Video Bitrate: select video bit-rate among six options: “128 kbps”,
“256kbps”, “512 kbps”, “1024 kbps”, “2048 kbps”, “4096 kpbs” according
to your network environment. The default video bit-rate is “2048 kpbs”.
⚫ Video2 Resolution: select video resolution for the second video stream
channel. While the default video solution is “VGA”.
⚫ Video2 Framerate: select the video framerate for the second video stream
channel. “25fps” is the video frame rate by default for the second video
stream channel.
⚫ Video2 Bitrate: select video bit-rate among the six options for the second
video stream channel. While the second video stream channel is “512 kpbs”
by default.
14.2. MJPEG Image Capturing
Fasttel door phones allow you to capture the Mjpeg format monitoring image if
needed. You can enable the Mjpeg function on Intercom > RTSP > RTSP Basic
and set the image quality on the web Intercom > RTSP > MJPEG Video
Parameters interface.
To Next Page
Loading...
