Fibocom L860-GL - Page 182

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 182 of 254
Command Description
Test [Function]
Test command returns (list of supported <cid>s), (list of supported <mode>s).
[Syntax]
AT+XDNS=?
[Response/Action]
+XDNS: (0-29) , (0-2)
i.e. (list of supported <cid>s), (list of supported <mode>s)
OK
Parameters
cid () please refer command +CGDCONT
<mode> may be
0 disable dynamic DNS Request (default)
1 enable dynamic DNS Request (Ipv4)
2 enable dynamic DNS Request (Ipv6)
<primary DNS>, <secondary DNS>
are the strings which represents the DNS addresses, and given as dot-separated
numeric
(0-255) parameter of the form:
a1.a2.a3.a4 for IPv4
a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16 for IPv6 and
a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.a17.a18.a19.a20 for
IPv4v6.(here a1 to a4 represent IPV4 and a5 to a20 represent IPv6)
The DNS address is by default "0.0.0.0" which is not a valid address.
Note: IPv6 address obtained on LTE will be prefixed with a constant 8 byte address
"FE.80.00.00.00.00.00.00" if network has not provided.
Example
AT+XDNS=0,1
OK
AT+XDNS?
+XDNS: 0, "0.0.0.0", "0.0.0.0"
OK
Reference