Fibocom L860-GL - Page 200

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 200 of 254
Command
Description
request to use GPRS.
<called_address> String that identifies the called party in the address space
applicable to the PDP. For communications software that does not support arbitrary
characters in the dial string, a numeric equivalent may be used. Also, the comma
character "," may be used as a substitute for the period character ".".
For PDP type OSP: IHOSS, the following syntax may be used for
<called_address>: [<host>] [@[<port>] [@
[<protocol>]]] where <host>, <port> and <protocol> are defined in
“+CGDCONT,Define PDP Context”.
For communications software that does not support arbitrary characters in the dial
string, a numeric value equivalent to the host name may be used. However, this
should
be avoided if at all possible.
<L2P> String variable which indicates the layer 2 protocol to be used.
For communications software that does not support arbitrary characters in the dial
string, the following numeric equivalents are used:
0 NULL
1 PPP
2 PAD
3 X25
9 yyyy M-xxxx
Other values are reserved and result in an ERROR response to the Set command.
Note: V.250 (and certain communications software) do not permit arbitrary
characters in the dial string. The <L2P> and <called_address> strings are
therefore specified as containing digits (0-9) only.
<cid>: Digit string which specifies a particular PDP context definition (See
“+CGDCONT, Define PDP Context”).
Example AT+CGDCONT?
+CGDCONT: 1,"IP","3GNET","10.168.15.100",0,0,0,0,0,0
+CGDCONT: 2,"IP","3GNET","10.227.131.75",0,0,0,0,0,0
OK
ATD*99***2#
CONNECT