Fibocom L860-GL - Page 243

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 243 of 254
Command Description
OK
Test [Function]
Test command returns supported values as compound value.
[Syntax]
AT+CSCON=?
[Response/Action]
+CSCON: (0-3)
OK
Parameters <n>:integer type
Enables or disables the presentation of an unsolicited result code
0 disable unsolicited result code. (default)
1 enable unsolicited result code +CSCON: <mode>.
2 enable unsolicited result code +CSCON: <mode>[,<state>].
3 enable unsolicited result code +CSCON: <mode>[,<state>[,<access>]]
<mode>:integer type
indicates the signalling connection status
0 idle
1 connected.
<state>: integer type
indicates the CS or PS state while in GERAN and the RRC state information if the MT
is in connected Mode while in UTRAN and E-UTRAN.
0 UTRAN URA_PCH state
1 UTRAN Cell_PCH state
2 UTRAN Cell_FACH state
3 UTRAN Cell_DCH state
4 GERAN CS connected state
5 GERAN PS connected state
6 GERAN CS and PS connected state
7 E-UTRAN connected state
<access>:
Integer type; indicates the current radio access type.