Fibocom L860-GL - Page 58

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 58 of 254
Command Description
parameters. This command works only in PREMUX state.
[Syntax]
+CMUX=<mode>[,<subset>[,< port_speed>[,<N1>[,<T1>[,<N
2>[,<T2>[,<T3>[,<k>]]]]]]]]
[Response/Action]
OK
or
+CME ERROR: <err>
Read [Function]
The Read command displays the current mode and settings. This command works only
in MUX state.
[Syntax]
+CMUX?
[Response/Action]
+CMUX: <mode>, [<subset>], <port_speed>,<N1>, <T1>, <N2>, <T2>, <T3>,<K>
OK
or
+CME ERROR: <err>
Test [Function]
The Test Command displays a list of supported modes and parameters. This command
works in both PREMUX and MUX states.
[Syntax]
+CMUX=?
[Response/Action]
+CMUX: (list of supported <mode>s),(list of supported<subset>s),[(list of supported
<port_speed>s)],(list of supported <N1>s),(list of supported <T1>s),(list of supported
<N2>s),(list of supported <T2>s),(list of supported <T3>s),(list of supported <k>s)