Fibocom L860-GL - Page 79

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 79 of 254
Command Description
[Syntax]
AT+CSMP=?
[Response/Action]
OK
Parameters <fo> Depending on the command or result code: first octet of 3GPP TS 23.040 [3]
SMS-DELIVER, SMS-SUBMIT(default 17), SMS-STATUS-
REPORT, or
SMS-COMMAND(default 2) in integer format.
<vp> Validity Period, depending on SMS-SUBMIT <fo>,
TP-Validity-Period-Format bits setting.
If there is no correlation between the VPF and the VP value. an error message will be
returned.
Either in integer format (see Table) or in time-string format ("yy/MM/dd,
hh:mm:ss±zz"). If in integer format the vp will write to SIM EF and read form SIM EF
when use it.
<pid> Protocol-Identifier. The one octet information element by which the SM-TL
either refers to the higher layer protocol being used, or indicates interworking with a
certain type of telematic device.
"0 - no interworking, SME-to-SME protocol (default) "Any value between 0-255 will be
accepted.
The SC may reject messages with a TP-Protocol-Identifier containing a reserved
value or one, which is not supported.
<dcs> One octet of Data Coding Scheme, indicates the data coding scheme of the
DATA, and may indicate a message class.
Note:
For DCS expanded information, see section “DCS handling”.
default alphabet: 00xx00xx, 111 100xx, 1 101xxxx
8 bit data: 00xx01xx, 111101xx
UCS2: 00xx10xx, 1110xxxx
reserved: 00xx11xx, 0100xxxx-1011xxxx
The default value at power-up is 0 - Default alphabet.
Example AT+CSMP?
+CSMP: 17,167,0,0 (default values for SMS-SUBMIT)