Fidelity Electronics A10 - Page 19

19
• If Piece Count working mode is set to On, set also the automatic piece weight enhancement function (APWE) parameter (** On
/Off).
• Refer to the operation manual for more information about automatic piece weight enhancement function.
3. Repeat the above procedures until instrument returns to F11.
Note: - If Note is set to On, F28 will be forced to Yes automatically.
F12
Auto Tare Function
** Off
On
Contin
Notes: -
• Off = Auto Tare Function disable.
• On = Only the first table weight applied will be tared off. Minimum tare load ≥ 2d.
• Contin = All stable weight applied will be tared off after the selected delay time. Minimum tare load ≥ 10d.
o If Contin is set, select also delay time (0.0 ~ 9.9 second). Delay time is the duration from a stable weight is detected until it is
automatically tare off.
o Delay time is displayed. Input the preferred delay time and press [Print/M+] to save.
F13
Repetitive Tare
Function
Off
** On
If F12 is set = Contin, Repetitive Tare setting “Off” will be surpassed.
F14
Function Buzzer
Kb (keypad buzzer)
(**On/Off)
St (System buzzer) (**On/Off)
Alibi Memory
(**On/Off)
To enable and disable a specific function buzzer: -
1. Press [Unit] or [MR] until the preferred parameter is displayed.
2. Press [Print/M+] to save and go to the next function buzzer.
3. Repeat the above procedures until instrument returns to F14.
F15
Check Result
Buzzer/Action on
Negative Value
Off
** in
out
Hi
Lo
 Off = Check Buzzer disabled.
 IN = Check Buzzer activates when reading is within range.
 ouT = Check Buzzer activates when reading is out of range.
 Hi = Check Buzzer activates when reading more than Hi limit.
 Lo = Check Buzzer activates when reading lower than Lo limit.