Chapter 5: System Software
5-35
Down Can
Prepares the FT-50 software for down can inspection by inserting
the necessary options into the software. When set to Not Present it
removes the options necessary for down can inspection from the
software.
This function does not activate or deactivate down can inspection,
it only readies the machine. To turn down can inspection on or off
you must use the Down Can Status function.
Down Can Text
Allows you to create a custom name for the Down Can Option.
Any instance in which “Down Can” would have appeared in the
software, is replaced by the custom label you created. The
following options are effected:
• Down Can Status
• Total Down Can
• Reset Down Can
• Width at Down Can
• Alarm Down Can
• Down Can Text
• Down Can
Note
This manual assumes the default name for this option. If you
change the default text remember to substitute the new name
when reading this manual. To avoid confusion record the change
in the manual.
To create a name:
1. Press the Arrow Key until the desired character appears.
2. Press Key 6 to advance to the next space.
3. Repeat steps 1 and 2 until you complete the entry and then
press Key 5 once to enter the text.
Industrial Dynamics Company, Ltd. Document 40255-0600
To Next Page
Loading...