Filtec FT-50c - Optional System Features; Bulged End Detection; Missing Lid Detection; Down Can Detection

To Next Page

To Previous Page

FT-50 Fill Level Inspector Service Manual

1-12

Optional System Features

The FT-50’s expandability allows you to add additional inspection

capabilities to match your production requirements. Depending

upon the FT-50 conﬁguration you ordered, your FT-70 may contain

some of the following features:

• Bulged End Detection

• Missing Lid Detection

• Down Can Detection

• External Reject Control

• Dud Detection (High and Low Container Pressure)

• Serial Controller Interface (Modbus or IDC Protocols)

• Programmable Logic Controller Interface (PLC)

Note

If you are unsure which options your unit contains, refer to the

System Conﬁguration Sheet located inside a clear plastic pouch

attached to the inside of the FT-50’s cover. The System

Conﬁguration Sheet included with your unit lists all options that

were installed at the factory.

Bulged End Detection

Detects container lids that are bulged due to excessive pressure or

contaner damage.

Missing Lid Detection

This feature detects the presence, or absence, of the container lid.

Down Can Detection

Uses an optical sensor to detect a can that has tipped over (down).

Dud Detection

Dud Detection detects improper pressurization of vacuum or

pressure sealed containers.

Industrial Dynamics Company, Ltd. Document 40255-0600