Chapter 5: System Software
5-43
54 Reject Queue Count
58 Abnormally Large Container Detected
61 Reject Delay Position Error
66 Fill Level Reject Detection is Turned Off During Inspection
67 Diameter Missing Lid Error-Exceeded Consecutive Reject Limit
68 Diameter Missing Lid Error-No Encoder Pulse
72 Production Line Speed Too High
86 BBU RAM Batter is Low
87 Broken Slat Or Pin
88 Broken Slat Sensor Failure
89 Slat Sensor Is Off
90 Broken Slat Sensor Adjustment Error
* 91 Broken Slat Pushplate
117 Modbus Serial Interface Framing Error
118 Modbus Serial RX Overrun Error
119 Modbus Serial Parity Error
120 Modbus Serial RX Receive Rate Error
121 Modbus CTS Line Rate Error
*
Error conditions that cause an alarm when the Beacon Status function is
set for High Priority Only.
Industrial Dynamics Company, Ltd. Document 40255-0600
To Next Page
Loading...