Trigger point #1 None
Trigger point #2 None
Trigger point #3 None
Silenceable Yes
Active on disablement (where applicable) Off
Trigger on event none
Delay from alarm Off
General options default values
Investigation delay 300s
Main fault delay 1m
Delay to alarm 60s
Silence duration 60s
Reset 2s
Loop 1 wires 4 wires
Loop 2 wires 4 wires
Loop 3 wires 4 wires
Day/Night mode Day mode
SC1 disablement Enabled
PSTN communicator enablement Not operative
IP communicator enablement Not present
NETWORK enablement Disabled
Delay from alarm #1 0s
Delay from alarm #2 0s
Delay from alarm #3 0s
Delay from alarm #4 0s
Delay from alarm #5 0s
PSTN communicator default values
Tone check On
Start playing after Selection
Call attempts 3
Iteration 3
Call all telemonitoring numbers No
Call all voice message numbers No
Telephone number label TEL. NUMBER xx(*****)
All Telephone numbers behavior None
Trigger events Panel alarm, Panel Fault
Message #1 to #7 Pre recorded
Notes:
(**) Automatically assigned Module label.
The label is composed by a brief description of the devi
-
ce followed by its address.
Automatically assigned Module channel label
The label is composed by a first part containing the mo
-
dule acronym and address followed by the brief de
-
scription of the channel using the acronym printed on
the module PCB.
xxx = module acronim
yyy= module address
For example "DDM098: Ingresso A" is the default label for
the input #1 of the FC410DDM module at address 98.
(****) tttt represent the on board output type (4 chars),
SC outpts -> tttt="SC "
Programmabel outputs -> tttt="OC "
y = output number
(*****) xx represent the telephone number ID (2 digits),
62 Addressable Fire Panel FC501
To Next Page
Loading...
