Guider IIS series User Guide | www.flashforge.com
2.1.2 Terms
The surface on which the Guider IIS builds an object.
The blue tape that covers Guider IIS 's build plate so that
the object can stick to the build plate well.
The three dimensional amount of space that an object
will use once it is completed. The largest build volume of
Guider IIS is 280*250*300 mm.
Knobs under the build platform that are used for
adjusting the distance between the nozzle and build
plate.
The device that draws the filament from the spool, melts
it and pushes it through a nozzle into the build plate.
Also called “print head”, which located at the bottom of
the extruder where heated filament is squeezed out.
To cool the outer assembly of the extruder and gear
motor.
An opening located at the top of the extruder.
A black plastic piece that guides the filament from the
filament box to the filament intake.
A specific box for placing FlashForge filament.
A solid adhesive used for making the model stick to the
build plate firmly.
A tool that used for cleaning and unclogging the
extruder.
A tool that used for seizing the nozzle’s metal cube.
To Next Page
Loading...
