Guider IIS series User Guide | www.flashforge.com
options, software will judge whether existing supports need to be deleted or
not on the basis of the type of existing support, and will pop up the
corresponding prompt to let you make the choice.
Click the [Auto Supports] button, the software will judge the position where
supports are needed and generate corresponding treelike or linear supports. If
it is a model with supports, the existing supports will be deleted and new
supports will be generated.
Supports will be added once clicking the [
Add
] button. Move the cursor to the
position where supports needed, left-click to choose the starting point of
supports, hold down the left mouse button and drag the mouse the supports
preview will show up (if support surface doesn’t need support or the support
column angle is too large, will highlight the support review). Loosen the left
mouse button, if support column doesn’t meet with model, then support will
be generated on origin and terminal point (the highlighted preview support
won’t generate support structure )
To Next Page
Loading...
