Guider IIS series User Guide | www.flashforge.com
Select the target object and scale the object by the following two methods:
Method 1: Click the [Scale] icon on the left, hold down the left mouse button
and scale the model. The corresponding values will display near the object.
Method 2: Click the [Scale] icon on the left and then enter into scale values in
X/Y/Z axes positioning. Click the [Maximum] button to get largest size
possible for building. Click
[Reset]
to reset the size of model.
Note: If the [Uniform Scaling] radio button is clicked, it will scale the model in
equal proportion when changing value in any positioning of the model.
Otherwise it will only change the value of the corresponding positioning.
Left-click on the model to select it and double-click on the
[Cut]
icon to set
the cut plane. The direction and position are available for setting.
To Next Page
Loading...
