Setting: To implement relevant function
setups.
Status: The check the real-time status
of the printer.
About: Information about the printer.
Back
Manual adjustment
Y+: The extruder moves to the zero
point, that is, the back of the machine
Y-: The extruder moves to the direction
opposite to the Y+.
X+: The extruder moves to the zero
points, that is, to the right direction
X-: The extruder moves to the direction
opposite to the X+.
Z+: The build plate elevates.
Z-: The build plate descends.
Back
Tap [Setting] to enter the setting interface
Language: To set the display language
Resume Print: Resume print after
restarting Guider IIS
WiFi: To turn on/off the WiFi
WLan hotspot: To turn on/off the WLan
hotspot.
To Next Page
Loading...
