Guider IIS series User Guide | www.flashforge.com
Chapter 5: Build Plate Leveling
Guider IIS series creatively adopts three-point intelligent leveling system,
which will give clear and comprehensive feedback to users. There are three
spring-loaded knobs under the build platform. The distance between the plate
and nozzle increases while tightening the knobs. On the contrary, the distance
(5-1) Tap
[Tools] - [Level]
on your Guider IIS series touch screen. Please wait
while the extruder and platform finish initial movements. After that, operate
according to the guide on the touch screen.
(5-2) After tapping [Yes], the extruder starts to move towards the first point
and the plate moves up and down to verify the distance between nozzle and
To Next Page
Loading...
