Guider IIS series User Guide | www.flashforge.com
The device must be placed in a dry and ventilated environment. The distances
of the left, right and back side space should be at least 20cm, and the
distance of the front side space should be at least 35cm.
Do not abuse the filament. Please make sure you use the FlashForge filament
or the filament from the brands accepted by FlashForge.
All polymers degrade with time. Do not unpack until filament is needed.
Filament should be stored at clean and dry conditions.
Legal Notice
All the information in this document is subject to any amendment or change
without the official authorization from FlashForge.
FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND WITH
REGARD TO THIS DOCUMENT, INCLUDING, BUT NOT LIMITED TO, THE
IMPLIED WARRATIES OF MERCHANTABILITY AND FITNESS FOR A
FlashForge shall not be liable for errors contained herein for incidental
consequential damages in connection with furnishing, performance or use of
To Next Page
Loading...
