Guider IIS series User Guide | www.flashforge.com
If successfully connected, you will see the following mark on the right corner.
Disconnect Guider IIS
Click [Print]--[Disconnect] to disconnect your PC and Guider IIS.
Method 3
：
Connect Via Ethernet
a. Connect your Guider IIS series with your PC via an Ethernet cable.
b. Turn on your Guider IIS series and start FlashPrint.
b. Click
[Print]-[Connect Machine]
on FlashPrint. Then the following
dialog box pops up. You need to select “Ethernet” in Connect Mode. Enter
into the IP Address shown on the interface and then click [Connect].
If successfully connected, you will see the following mark on the right corner.
To Next Page
Loading...
