Guider IIS series User Guide | www.flashforge.com
option. If you can not find your machine, click the
[Rescan]
button to scan
your machine and select it. Finally click [Connect] button to connect to the
printer. If you still can not find your machine after rescan, it means you haven’
t installed the driver in the software.
Method 2： Connect Via WiFi
①Connect Guider ⅡS with your PC under AP mode
b. Tap [Tools]-[Setting]-[WLan hotspot]-[WLan hotspot ON].
c. Click on the wireless network setting in your computer, and find the
wireless signal-“
Guider
Ⅱ
S
”. Click
[Connect]
to connect your computer with
Guider ⅡS via Wlan hotspot.
d. Click [Print]-[Connect Machine] on FlashPrint. Then the following
dialog box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into
the IP Address shown on the interface and then click [Connect].
To Next Page
Loading...
