FLASHFORGE 3D PRINTER Guider IIS Series - Exploring the FlashPrint Interface

Guider IIS series User Guide | www.flashforge.com
6.2 Exploring FlashPrint
6. 2.1 Machine Type Selection
! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just select FlashForge
Guider ⅡS in the machine type list and click [OK]. You can also change the
machine type via clicking [Print]--[Machine type]. See graphic 6-2:
6-2
6.2.2 Software Introduction