FLASHFORGE 3D PRINTER Guider IIS Series - Unloading Filament

Guider IIS series User Guide | www.flashforge.com
(4-8) Tap [Filament]--[Load]
4-9
（4-9）After the extruder's temperature reaches 220℃, the printer will sound a
beep to prompt you to load the filament into the extruder.
4-10
（ 4-10 ） Insert the filament into the extruder at an upright angle. Then the
filament will be drawn through the extruder. Do not tap
[Cancel]
until the
filament load the extruder steadily.
4.4 Unloading Filament
4-11