FLASHFORGE 3D PRINTER Guider IIS Series - Connect Guider ⅡS with Your PC under STA Mode

Guider IIS series User Guide | www.flashforge.com
If successfully connected, you will see the following mark on the right corner.
②
Connect Guider
Ⅱ
S with your PC under STA mode
a. Tap [Tools]-[Setting]-[WiFi]-[WiFi ON] to turn on the Wi-Fi of Guider
IIS and connect your computer and Guider IIS with the same WiFi signal.
b. Click
[Print]-[Connect Machine]
on FlashPrint. Then the following
dialog box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into
the IP Address shown on the interface and then click [Connect].