Guider IIS series User Guide | www.flashforge.com
① Do not touch the nozzle and build plate during printing.
② Do not touch the nozzle after finishing printing.
③ Dress properly. Do not wear loose clothing or jewelry. Keep your hair,
clothing and gloves away from moving parts.
④ Do not operate the device while you are tired or under the influence of
drugs, alcohol or medication.
① Do not leave the device unattended for long.
② Do not make any modifications to the device.
③ To lower the build plate before loading/unloading filament. (The distance
between the nozzle and build plate should be kept for at least 50mm)
④ Operate the device in a well-ventilated environment.
⑤ Never use the device for illegal activities.
⑥ Never use the device to make any food storage vessels.
⑦ Never use the device to make any electrical appliance.
⑧ Never put the model into your mouth.
⑨ Do not remove the models with force.
⑩ Never connect the device with network cable longer than 3m.
· Environment Requirements
To Next Page
Loading...
