Guider IIS series User Guide | www.flashforge.com
the surface has steep overhang and it becomes red in the software. Overhang
threshold value could be set as needed. The default value is 45 degree.
Select the object and move the object by the following two methods:
Method 1:
Click the
[Move]
icon on the left, hold down the left mouse button
and drag to adjust the location of the model in XY direction. Hold down the
Shift key, hold down the left mouse button and drag to adjust the location of
the model in Z direction. The distance and the direction of the movement shall
Method 2: Click the [Move] button on the left and then enter the distance
value. Click [
Reset
] to reset distance values.
Note: Users shall click [Center] and [On Platform] after the location
adjustment to ensure the model(s) be within the build area and on the build
platform. If a specified position is needed, only click
[On Platform].
Select the target object and rotate the object by the following two methods:
Method 1: Click the [Rotate] icon on the left and three mutually perpendicular
rings appear around the object Click one ring and rotate on the present axis,
you will see the rotation angle and direction in the center of circle. In this way,
you could make the model rotate on X/Y/Z axis.
Method 2: Click the [Rotate] icon on the left, and then enter into rotating
angel values in X/Y/Z axes positioning. Click
[Reset]
to reset rotating angel
To Next Page
Loading...
