FLASHFORGE 3D PRINTER Guider IIS Series - Hardware Assembly; Filament Installation Procedure

Guider IIS series User Guide | www.flashforge.com
Chapter 4: Hardware Assembly
Your Guider IIS series has been installed before leaving factory, you can start
up the Guider IIS series for printing after mounting the filament spool and
completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of Guider IIS. Lift the cartridge out of
the Guider IIS.
4-2
Filament Detecting
Equipment in the black.