Guider IIS series User Guide | www.flashforge.com
After loading the model, click [
Edit]--[Supports
] or click the
Supports
icon
directly, then you will enter the support edit mode (as shown in the picture
below). Click [Back] to exit when you finish editing.
Click the Support Options, an option box will appear, supports options include
treelike and linear, when choose treelike, click [OK], then it will generate
treelike structure; when choose linear", click
[OK]
, then it will generate linear
structure;if it is a model with supports, when you choose one of the supports
To Next Page
Loading...
