FLASHFORGE 3D PRINTER Guider IIS Series - Print Setup and Configuration

Guider IIS series User Guide | www.flashforge.com
（ 7-4 ） Click
[Edit]--[Surface to Platform]
to make your model perfectly
positioned on the build area. Click [Back] and double-click the Move icon
again, then click [On the Platform] and [Center] to ensure the model be on
the platform.
7-4
Note
：
If you
’
ve place your model in a right place, you can skip the step
above.
(7-5) Click the [Print] icon on the top, you should make some setups for your
print job.