Enable or disable the collision sensor in FlowCUT
Quick reference for how to enable or disable the DCF's collision sensor in FlowCUT.
To enable the collision sensor
1. Click Option Component .
2. Scroll down until you see Enable collision sensor, click 1, and then click Close.
To disable the collision sensor
1. Click Option Component .
2. Scroll down until you see Disable collision sensor, click 2, and then click Close.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Dynamic Contour Follower
To Next Page
Loading...
