Cross-flow separation
Where used
ATS 2200 and ATS 4400
Cross-flow separation dislodges and removes settled solids from the catcher tank in a closed loop
process that does not consume any water. In Cross-flow mode, the pump will operate at approximately
110 strokes per minute which will move 50–60 gallons per minute through the machine. Settled material
is pulled through the cross-flow separator and deposited into the bulk bag. Clean water (free of settled
material) is returned to the catcher tank through the discharge hose.
To use Cross-flow mode, do the following:
1. Attach shop air hose to the VacBOX pump. Air setting should read between 50-60 psi.
2. Rotate the yellow ball valve handle until it is parallel to the pump suction manifold.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Abrasive Transfer System (ATS)
To Next Page
Loading...
