Plumbing
Air
Air supply …………… dry and filtered to 10 microns
Capacity …………… 538 L/min @ 6.9–8.3 bar (19 scfm @ 100–120 psi) per Z-axis end effector
*
Interface type …………… ¾ in. BSPTF
*If machine has UltraPierce Vacuum Assist, an additional 538 L/min @ 6.9–8.3 bar (19 scfm @ 100–120 psi) per Z-axis
end effector is required.
Drain
Capacity …………… 8 L/min @ 0 bar (2 gpm at 0 psi) minimum per cutting head
Interface type …………… 1 in. NPT
© 2021 Flow International Corp.
Retrieved from Flow KB on April 13, 2021 PST
Facility requirements · Mach 300
To Next Page
Loading...
