Shut down the machine · (A)
Where used
Mach 500 · Mach 300 · Mach 200
When you shut down the machine, follow these steps:
1. Jog the cutting head to a loading or safe position.
2. Exit all programs.
3. Press the E-stop.
4. Click Start, and then click Shut down to turn off the machine PC.
5. Wait until the machine PC is completely shut down, and then switch off the main power to the
machine (pump and machine disconnect).
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Get started: Operation Basics · Mach 300
To Next Page
Loading...
