Light curtains
When one or more beams from the light curtains are interrupted, a stop signal is sent to the controller
and the following occurs:
• Part programs stops and error message is displayed
• Axes travel stops
• On/off valve closes
• High-pressure pump is shut off and the high-pressure lines are depressurized
However, if the machine is in Set-up Mode and the light curtain beam is interrupted, an E-stop condition
does not occur.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Light curtains
To Next Page
Loading...
