3. Remove the water from the top of the bag:
a. Disconnect the suction hose from the top of the pump and connect the 1” X 6’ dewatering
hose into the CAM fitting on the pump inlet.
b. Turn on the air supply to the pump, and then use the dewatering hose to vacuum the
remaining water from the top of the bulk bag and remove excess water and silt from the
channel between the bag cage and outer chamber of the machine.
Bag dewatering for the ATS 4400
For ATS 4400 bag dewatering, do the following:
1. While the machine is in operation, remove the suction and discharge hoses from below the
water level, but leave them over the catcher tank to remove excess water from the cross-flow
separator. After several seconds, the discharge hose will stop discharging water. Once this
occurs, it's okay to raise the lid on the VacBOX to continue manual dewatering.
2. Remove the water from the top of the bag:
a. Disconnect the suction hose from the top of the pump and connect the 1” X 6’ dewatering
hose into the CAM fitting on the pump inlet.
b. Turn on the air supply to the pump and use the dewatering hose to vacuum the remaining
water from the top of the bulk bag.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Abrasive Transfer System (ATS)
To Next Page
Loading...
