Remove the bulk bag
Where used
ATS 2200 and ATS 4400
To remove the bulk bag from the VacBOX, do the following:
1. Expose the lifting straps from all four corners.
2. Connect the four straps to lifting equipment—such as a forklift—and lift the bulk bag from the
VacBOX chamber.
CAUTION! Ensure the straps are protected from any sharp edges on the lifting device to
avoid cutting the straps and dropping the load. Immediately transfer a fully loaded bulk bag to a
pallet for safe transportation to storage/disposal area. If you are using a forklift, carefully
approach from the side to avoid damage to the VacBOX lid and/or seals.
3. Use a garden hose to rinse all garnet/mud from the bottom of the machine (under the floor of
the bag).
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Abrasive Transfer System (ATS)
To Next Page
Loading...
